MantaMesh Wire Mesh Decking Wire Mesh Decking Panels
sit over pallet racking beams.
They have inbuilt welded
support channels.
Particleboard Shelving
Particleboard Retainer Clips For light applications, the board
can be used unsupported being held in place using Particleboard Retainer
Clips (Z clips).
Board Support Channels
For heavier applications, the use of Board
Support Channels increases the carrying capacity of the board and locks
the board into position.
Column Guard
The column guard is bolted to the floor in front of the uprights providing
protection from forklifts to the bottom portion of the upright.
As it is not connected to
the upright it takes all impact.
Barrel Chocks
Barrel Chocks are used when barrels or drums are to be stored on Pallet
Racking Beams. They prevent the barrel from rolling along the beam.
The Barrel chocks are fitted over the
front beam or both front and rear beams, but are not fixed.
Fork Entry Bars
These are used when unsuitable pallets or unpalletised loads are to be
stored on beams and handled by forklift trucks.
The bars provide a gap of approximately
75mm above the beam for forks.
Pallet Support Bars
Supported at each end by the beams, Pallet Support Bars provide a
secondary support member for pallet racking.
The Pallet Support Bar is designed to
have its top surface flush with the beams.
